A buddy of mine, Sinza who started the Exotic Automatic forum we run together (you should go check it out: http://exoticautomatic.com) sent in a link to an interesting weapon a while back. It’s basically a pushdagger, to be exact, and a rather ornate one at that, but this one gets brownie points because it just so happens that it bears my name:

Fire Blade

Fire Blade

Ok, so we don’t have exactly the same name, but it’s close enough. Go figure, a genuine Fire Blade! And, the cool thing is, unlike the many other really flashy but useless pieces I run into all the time, this one is actually usable. Ergonomically designed even… Yay for our side!!

So what we have here is a really flashy punch dagger design, with basically has three blades, all attached to the an ornately cast “T” shaped grip, with the center blade attached to the center stem of the “T” which expands out into a smaller, internal sub guard over the center finger area, and each additional blade attached to either side of the main grip.

As grips go, this one is very elaborately designed, with an organic, almost coral like motif cast into the surface of the entire grip. At either side of the palm side of the grip, extend what looks like little set of branches arcing upwards towards the wielder.

Moving down past that we see the ends of the grip both angle down towards the front blade, while, from the center of the grip, extends a short stalk. And at the ends of each of these points, we have our blades. An unusual feature of this grip is that it has multiple choils, of finger guides, along the front, theoretically to give you a better grip. Ergonomics at work.

But it is the blades where the magic happens. Most notably on the side blades. Each side blade is cut into an interesting Asian flame pattern, with the flame front sporting a rather wicked looking edge on either side. the center blade is less obviously flame patterned, featuring two side licking flames, and a split center blade.

All in all, a rather flamboyant design, but not too bad in the practicality department either. The side blades appear to be fairly sturdily attached, and assuming they have more than a short stub tang embedded in the handle casting, should be fairly strong, and take side slashing duty fairly effortlessly.

The center blade, well, I’d much have preferred to see a slightly thicker center stem, however for thrust duty, (again assuming a more than minimal tang) it should suffice. I Just wouldn’t try anything that might place shearing forces on that particular joint. It’s a design flaw that seem very common with decorative push dagger designs.

Overall, this design is a little overboard on the fancy flash factor for yours truly, but it’s certainly a practically feasible design. And given it’s name, it just had to get a post… Call me biased… ๐Ÿ˜€

Fire Blade – [Ninja-Weapons]

Exotic Automatic – [http://exoticautomatic.com]